Vacuum coating equipment coating machine

Vacuum coating equipment coating machine

Vacuum coating vendors would vacuum coating equipment vacuum coating when replace electroplating is the biggest challenge facing the diffraction properties of film layer preparation. Because the vacuum coating is done in a vacuum film preparation, film deposition is parallel to the evaporation source, workpiece must be in the face of the evaporation source, use widgets more structure, vertical plane of the... deposition rate even in preferable magnetron sputtering diffraction also is parallel to the plane of the evaporation source only one 5 of the deposition rate. More than this, the vacuum coating for the surface more artifacts or circular workpiece, cannot be used for complex artifacts, which are greatly limited the application of vacuum coating to replace water electroplating, slow down the pace of the application of vacuum coating of green environmental protection. For fasteners, the six sides need coating workpieces, usually using vacuum coating clips, hang card, will make the workpiece surface coating not blind spots, acid and alkali and water vapor and oxygen erosion, forming erosion point will aggravate corrosion of fasteners and so cannot use vacuum coating commonly used clamp fixed artifacts, hang card, and so on.
In order to solve this problem, this project designs a unique basket cage type workpiece, such as screw bolt fasteners in a workpiece in the basket, basket inside the cloth has a flip flap, when the basket cage workpiece cycloid reciprocating motion, fasteners, form the new face of sedimentary source side, multi-layer flip, so as to realize uniform coating of every side of fasteners.